[jira] [Commented] (ACCUMULO-550) Colocate rfile index entries within file

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view

[jira] [Commented] (ACCUMULO-550) Colocate rfile index entries within file

JIRA jira@apache.org

    [ https://issues.apache.org/jira/browse/ACCUMULO-550?page=com.atlassian.jira.plugin.system.issuetabpanels:comment-tabpanel&focusedCommentId=13403879#comment-13403879 ]

Adam Fuchs commented on ACCUMULO-550:

I noticed yesterday when working on ACCUMULO-652 that the index entries at level 1 and higher are still interspersed between level 0 blocks with the current technique. Is there value in keeping indexes at a given level greater than 0 close to each other, or is that overkill?

> Colocate rfile index entries within file
> ----------------------------------------
>                 Key: ACCUMULO-550
>                 URL: https://issues.apache.org/jira/browse/ACCUMULO-550
>             Project: Accumulo
>          Issue Type: Improvement
>          Components: tserver
>            Reporter: Keith Turner
>            Assignee: Keith Turner
>             Fix For: 1.5.0, 1.4.1
> Before multi-level indexes were introduced, when an an rfile was written its entire index was held in memory and written out then the file was closed.  With the introduction of multilevel index each index block is written when it fills up as the file is being written.  This was done to handle the case where the index may not fit into memory.  This leads to index blocks being sprinkled through the file.   So any operation that iterates over the entire index can be slow because it turns into a lot of random accesses.  
> One possible solution is to buffer lots of index blocks up to some some threshold and write out alot of index blocks at once.  This would make a scan of the index much faster as it would turn into a set of sequential reads of large chunks of data.
> Could buffer all block at a particular level and write them out when the parent index block fills up.

This message is automatically generated by JIRA.
If you think it was sent incorrectly, please contact your JIRA administrators: https://issues.apache.org/jira/secure/ContactAdministrators!default.jspa
For more information on JIRA, see: http://www.atlassian.com/software/jira